Lynx Studio LT-HD User Manual
Page 10
Page 7
8.
Secure LT-HD with three screws; one on the standoff and two from the back panel of
Aurora. Keep screws loose until LT-HD is properly aligned, then tighten snugly, but do
not overtighten.
9.
Reinstall the Aurora lid using the eight screws that had been removed. Do not over
tighten the small screw near the center of the front faceplate as it is easily damaged.
10.
Plug in and power up the Aurora using the front panel standby switch. You can see the
LT-HD from the slits in the Aurora lid. If the green LED on the LT-HD lights up, the
installation was successful. If the LED does not light, unplug the Aurora and re-mount
the LT-HD, making sure that it is securely attached. Then plug in and power up again. If
the green LED still does not light, contact Lynx Customer Support (949-515-8265 X206).