Lynx Studio LT-HD - Manual (Page 7)

Page 4
6 Installation Procedure
1. Remove the AC power cord and take the top off of the Aurora 16 or Aurora 8. There are
seven large screws plus one small screw near the center of the front faceplate.
2. Before installing the LT-HD card, there is a jumper setting on the Aurora that corrects the
current draw for an Aurora with an LT-HD.
If you are updating a Rev A. Aurora, remove jumper W3 from the JP6 header on the
Aurora mainboard.
If you are updating a Rev B Aurora, slide switch 4 (labeled W4 on PCB) of
SW1 to the OFF position (towards back panel)