Lynx Studio LT-HD - Manual (Page 20)

Page 17
9.2 I/O Setup Page
This page within the ProTools software is where active input and output devices that are defined
in the hardware setup page are assigned to record and play channels for use by tracks and busses
within ProTools.
Click on the INPUT, OUTPUT, and INSERT Tabs and click “default” to create signal paths
based on the I/O defined in the Hardware Setup page. Afterwards, it is generally helpful to re-
label these paths to correspond to Aurora channels (i.e. Aurora Analog In 2, Aurora Digital Out
3, etc.) or to the name of front-end devices which are plugged into the Aurora (i.e. Mic Preamps,
Mixer outputs, etc.).
In cases where the ProTools labels do not define the Aurora I/O type used (i.e. Analog Out 9-16
accessed as AES/EBU Out 1-8 in 16-channel mode), labels can be created here for clarification.