MBM Corporation iCREASE EXCEL User Manual
Page 9
Feeder Mode
Feed mode is the mode to run your icreaseEXCEL as a feeder into our CountCoat UV Coater. It
runs much slower than the other modes giving the sheets enough spacing to move through the
UV coater.
Home: Takes you back to the home screen.
Counter Reset: Resets the displayed counter to 0.
Jog Left and Right: Slowly advances the rollers left or right.
Batch Counter: Allows for stopping the machine after a batch number is reached.
Run: Turns on the transport and starts the feeding of paper.
Crease mode
Crease mode is used to apply a Compression Crease/Score to a piece of paper. In this mode
there are several Automatic Setup selections or you can do a custom selection and enter the
distance in mm.
Crease selections include half, tri-fold, z fold, letter fold, roll fold, gate fold, double gate, double
parallel, 3 perfect bind selections and 12 custom crease locations.
6