MBM Corporation iCREASE AIR - Manual (Page 25)

CHECKING THE SENSORS
1. Turn machine power on and allow screen to turn on
2. There should be 2 lights on the sensor; a green indicating power is getting to the
sensor and orange that is the reflecting signal. If both lights are not on there is a
problem and must be fixed before you are able to run.
3. Make sure the sensor reflector tape is located on the base plate and the red beam
from the sensor is hitting the tape. If not loosen the screws on the sensor and adjust
the beam until it is on the tape.
4. If all above steps work correctly, the sensor is working properly, if not, contact the
MBM Corporation service department.
DRIVE CHAIN TENSION
The chain that drives the upper crease die in time will stretch. This is a common
occurrence in chains. The spring tensioner bracket will automatically adjust the tension.
It is important that this chain remain taut and free of any play. It is recommended to
check this periodically. If there is play in the chain drive, make sure the adjustment
spring is in the correct location.
PERF SHAFT & STRIKE PLATE
22