MicroLinks UM06 - user guide - Manual (Page 16)

14
the application program to focus the image.
(2) Fixed image sensor position
(2-1) In HDMI mode, the status bar will show on the screen (please refer to
Section 1.2.3-(9)). Use the remote controller to adjust the image sensor
position based on magnification size, FOV, or distance height.
(2-2) In PC CAM mode, choose the desired height or FOV from the drop
down list in the application program (see figure below).
When the image sensor position is fixed, as in (2-1) and (2-2), focus the image
by using knob ○
j
to adjust the height and knob ○
k
to fine tune.
○
j
○
k
○
j
○
k