MicroLinks UM02 - user manual - Manual (Page 32)

Microscope Application Program http://www.ViTiny.com
32
Copyright © 2008-2012 MicroLinks Technology Corp.
5. Mode Functions
When connecting the AP with MICROSCOPE, the four mode functions will show up on the
button position under left sub-window. See Fig.5-1.
 Comparison mode{Refer to section 5.1} ：
Comparison mode can do overlapping two frame. The frame can be whole or any size to
compare. This mode can see two frams of simiarities.
 Aiming mode{Refer to section 5.2} ：
Provides a cross, area, rectangle and circular different aiming mode to aim the observation
object .That can help capture observation object.
 Video control mode {Refer to section 5.3} ：
The mode can control left hand or right hand to hold the machine, which can capture yourself or
opsiticles, but the directions might not be correct. It can use the mode to adjust the dirctions and
it can adjust contrast, brightness and exposure.
 Measurement mode {Refer to section 5.4} ：
Measurement mode has ruler functions to measure at real time, which provides different
measurement tools.
5.1 Comparison mode
When connected, the defult of the toolbar is set as to compare shown in Fig.5-2 and Fig.5-3.
In Fig.1-6 right sub-window has no image so some part of the buttons wouldn‟t work in this
mode. Comparesion mode can be overlap with another video image to compare and to cut half of
the image for comparession.
Fig.5-2 Comparison mode
Fig.5-3 Comparison mode toolbar
5.1.1 Load right side image “
”
When capture one imge or open one image, the Comparison toolbar of “load right side