MicroLinks UM02 - user manual - Manual (Page 54)

Microscope Application Program http://www.ViTiny.com
54
Copyright © 2008-2012 MicroLinks Technology Corp.
Figure 5-54 Setting effective horizontal dimension on monitor
When the “magnification display” is checked, as shown in Fig. 5-54, the
magnification ration will show on the upper right corner of the display window
based on display size, image resolution and preview window size. The ratio is
calculated by Field of View. Field of View is the calibrated horizontal and
vertical scale. Users could also calculate the ratio by rulers, please refer to Fig.
5-56. The displayed 1.00 mm equals to 16.2mm ruler scale, therefore, this is 16.2
times the actual size.
圖 5-55 The magnification ratio on the
upper right corner
圖 5-56 measure ratio by ruler
 Ratio displayed on the picture
Fig. 5-57 shows the options for ratio display. Choose the display way first, then
click 「 」in measurement mode to save the picture, the ratio will be saved and
shown on the upper right corner; or click 「 」to copy the preiviewed image to
previewed picture. If “monitor” is selected, the ratio displayed on the picture is
calculated by current image size and Filed of View. If “print” is selected, the ratio
is calculated by current image size, Field of View and printing resolution (the
default setting is 960dpi). If “both” is selected, both of the ratio will be displayed
as Fig. 5-58. The “S” represents screen ratio while “P” represents printing ratio.