Montigo H38DF - Manual (Page 26)

Page 26 XG0147 - 150204.1
H*38DF Gas Fireplace
Installation
Section 9: Installing the Accessories
Figure 27k. Front Left Log, (Log F).
Installing the Log set:
The H38DF* is supplied with a six ceramic fibre log logset. Unpack the
logs and handle them very carefully.
Step 1. Remove the glass door as described in the previous Instructions.
Air Inlets
Pilot Assembly
Fireplace Base
Rear / Bottom Log
Notch in Log
Log A
Air Inlets
Fireplace Base
Log D
Figure 27i. Top Left Log, (Log D).
Air Inlets
Fireplace Base
Log E
Step 5. Place Front Left log (Log D) as shown in figure 27c.
Figure 27j. Top Right Log, (Log E)..
Step 6. Place Front Right log (Log E) as shown in figure 27e.
Fireplace Base
Log F
Air Inlets
Fireplace Base
Log C Log B
Step 7. Place Front Left log (Log F) as shown in figure 27f. Set notch
in lower end of Log F against stile on Log Grate.
Figure 27l. Completed Logset.
Figure 27g. Bottom Rear Log, (Log A).
Step 2. Place the bottom Rear log (Log A) as shown in figure 27a.
Figure 27h. Left front Log, (Log C) and Right front Log, (Log B).
Step 3. Place the bottom Right log (Log B) and bottom Left Log, (Log
C) as shown in figure 27b.
If logs are not placed properly, excessive sooting will result.
NOTICE