Montigo H38DF - Manual (Page 29)

Page 29 XG0147 - 150204.1
H*38DF Gas Fireplace
Installation
Figure 30f. Placement of (8) eight LH & RH Side "C" faux ceramic
rocks. (Marked). Note: approximate location and placement. (Place
on top, in between the lower layer rocks in a pleasing pattern).
4. Next step, install the Upper (8) eight Faux Rock "C" as shown in
Figure 30f. Note: place cut surfaces of Rocks face down on lower
Rocks.
Figure 30h. Completed Placement of Faux Rocks
Note: You may have to adjust these three Faux rocks to produce
a pleasing flame pattern and reduce sooting.
„
„
„
„
„
„
„
„
5. Next step, install the Front (3) three Center Front Faux Rocks "D"
as shown in Figure 30g & 30h. Note: place cut surfaces of Rocks
face down on lower Rocks.
Figure 30g.
„ „ „
RH-LH Side faux Rock "C"
Installing the Wildfire Log set:
The HW38DF* is supplied with five ceramic fibre logs. Unpack the logs
and handle them very carefully.
Step 1. Remove the glass door as described in the previous Instructions
2. The base log is factory-installed.
3. Arrange the ember chips on top of the burner tray. Care should be
taken when placing the ember chips, as blocked burner ports may
cause an incorrect flame pattern, carbon deposits and delayed
ignition. Also, the chips must never be placed in a way that obstructs
any of the air inlet ports, located at the rear of the burner, as shown
in figure 31b.
Figure 31a. Bottom left & right log placements.
Base Log
Log Base
Bottom Left Log Bottom Right Log
Back Left Log
Mounting Tray
Bottom Right Log
Mounting Tray
Bottom Left Log
Mounting Tray
Figure 31. Log mounting base, placement locations.
All ceramic fibre Logs have been designed to enable quick and easy
placement. Please follow the instruction below.
Back Left Log
Step 2. Place the bottom left and right logs as shown above in
figure 31a.
Notch
Figure 31b. Back Left log placement.