Installation, Installing the power vent – Montigo PVHFL58-300 User Manual
Page 4
Advertising
Installing the power vent
18 34 "
476
22 14 "
565
Framing
Wall Board
Outer Can
Assembly
Figure 2. Framing dimensions
Installation
Step 1: Unpack power vent from box. Remove two screws from bottom of the
door. Hold louver assembly securely so it does not fall.
Figure 3.
Step 2: Remove the louver assembly by lifting the bottom end forward and
then dropping the door out of the top latches.
Figure 3a.
Step 3: To remove the inner can from the outer can remove the 8 screws on
the back of the termination.
Figure 3b.
PVHFL58-300 & PVHFL510-300 Horizontal Power Vent
Page 4
XG0519 - 070714
Advertising
This manual is related to the following products: