Montigo 34DVI Tuscany - Manual (Page 12)

Page 12
Tuscany
Gas Fireplace Insert
P/N XG0515
Operation Section 9
Irritant Cutting Watch your step Slippery floor High temperatures Glass hazard Danger of suffocation
High voltage Toxic Flammable materials Corrosive Fork lift trucks Danger overhead crane Explosion risk
Oxidising Danger of death Biohazard Laser Radiation Danger of entrapment Hot surface General Warning
Blank
Gas bottles Watch for
falling objects
Electricity Danger for cutter Entrapment hazard Battery hazard Rotating parts
Low temperature Strong magnetic field Optical radiation Non ionizing
radiation
Radiation Hazardous to the
Environment
Danger of harming
your hands
WArnInG
If you do not follow these instructions exactly, a fire or explosion may result causing property
damage , personal injury or death.
phone. Follow the gas supplier's instructions.
Q
If you cannot reach your gas supplier, call the Fire
Department.
c. Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by hand,
don't try to repair it, call a qualified service technician. Force
or attempt to repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system, and
any gas control which has been under water.
A. This appliance has a pilot which must be lighted by hand.
When lighting the pilot, follow these instructions exactly.
B. BeFore lIgHtIng smell all around the appliance area for
gas. Be sure to smell next to the floor because some gas is
heavier than air and will settle on the floor.
What to Do If You smell gas:
Q
Do not try to light any appliance.
Q
Do not touch any electrical switch; do not use any phone
in your building.
Q
Immediately call your gas supplier from a neighbour's
To Turn Off Gas To Appliance:
3. Push in gas control knob slightly and turn clockwise to
"Off". Do not force.
4. Replace the lower Horizontal access panel.
1. Turn off remote switch.
2. Lift out the lower Horizontal access panel.
SIT Nova 820
with American Flame Electronic Ignition
For Your Safety - READ BEFORE LIGHTING:
Lighting Instructions:
1. stoP! Read the safety information above on this label.
2. Lift out the lower Horizontal access panel.
3. Push in gas control knob and turn clockwise
to "OFF."
4. Wait five (5) minutes to clear out any gas. Smell for gas,
including near the floor. If you then smell gas, stoP! Follow
"B" in the safety information above on this label. If you don't
smell gas, go to the next step.
5. Locate pilot burner (See illustration at right.) and follow steps
below.
6. Turn knob on gas control counter clockwise to "PILOT."
7. Push in gas control knob completely and hold. Light with Piezo
Igniter button. Continue to hold the control knob in for about
(1) minute after the pilot is lit. Release the knob and it will pop
back up. Pilot should remain lit. If it goes out repeat steps 3
through 8.
Q
If knob does not pop up when released. Stop and
immediately call your service technician or gas supplier.
Q
If the pilot will not stay lit after several tries, turn the gas
control knob to "OFF" and call your service technician
or gas supplier.
8. Push in gas control knob and turn counter-clockwise to
"ON."
9. Replace the lower Horizontal access
panel.
10. Turn on remote switch to ignite fire.
note: Gas control knob cannot be turned from "PILOT" to "OFF"
unless knob is pushed in slightly. Do not force.
Model# 34LDVI; 34RDVI; 34HDVI