Dolby Laboratories DVD/VCR Combo - Manual (Page 20)

- 20 -
Adjusting the Sound
The following tables show which speakers are working in the various modes.
REMARKS:
1) Generally, only Front Left, Right speakers and Subwoofer are active at TUNER mode.
2) "
" The speakers is activated.
3) " X " The speakers is not activated.
4) Always keep your VCR in stereo mode otherwise the speakers output status may be different to above listed table.
5) You can only set 5.1 CH, 2.1 CH when the disc is stopped.
6) In Subwoofer On mode, if speaker is set to "Large", then the output of subwoofer is low.
To select the listening channel
1. When the disc is stopped, you can press 5.1 CH and 2.1 CH buttons on the remote control to select different
speakers output status shown as below table.
2. You can active or off subwoofer output by setup menu.
Note:
The wording "2.1 CH" will be corresponded to the audio/sound output from Front Left and Front Right speaker
plus the Subwoofer.
5.1 CH /
2.1 CH
Subwoofer
L/R
Speaker
Front Left
Speaker
Front Right
Speaker
Center
Speaker
Subwoofer
Rear Left
Speaker
Rear Right
Speaker
Small
Large X
Small /
DVD Large
CD Small /
Large
Small /
Large
Audio Settings Speakers Output Status
DISC
ON 5.1 CH
5.1 CH
2.1 CH
2.1 CH
OFF
ON
OFF
X
X
X
X
X
X
X
X
Output
Channel
3 Stereo /
Pro Logic
Subwoofer
L/R
Speaker
Front Left
Speaker
Front Right
Speaker
Center
Speaker
Subwoofer
Rear Left
Speaker
Rear Right
Speaker
TUNER N/A N/A N/A N/A X X X
ON Small
Pro ON Large X
Logic Small /
Large
ON Small X X
ON Large X X X
Small /
Large
Small /
Large
Small /
Large
3 CH
2 CH
VCR /
AV_IN
Audio Settings
Sources
OFF
3 Stereo
OFF
OFF
ON
OFF
4 CH
X X X X
X X X
X X X
Speakers Output Status
X