Vcr setup, Clock, Enter – Dolby Laboratories DVD/VCR Combo User Manual
Page 45
- 45 -
VCR Setup
(continue on next page)
(continue on next page)
(continue on next page)
(continue on next page)
(continue on next page)
SELECT :
ENTER : SET
MENU
TIMER
SET UP
CHANNEL PRESET
LANGUAGE
CLOCK
EXIT : MENU
MENU
CLOCK
AUTO
MANUAL
EDS CH SET AUTO
MANUAL
EDS CH 02
ENTER
ENTER
4. Select a channel that carries EDS signals with the cursor or button.
EX:
07
• The number of channels that can be selected depends on the mode setting on the CHANNEL PRESET
screen. See Notes.
When using a cable box: Input the output channel (02, 03 or 04) of the cable box.
5. Press the ENTER button to enter. The screen returns to normal.
Press the VCR ON/OFF button to turn off the VCR (TAPE IN indicator will turn off and VCR ON indicator will turn
off).
The Auto Clock Setting function will automatically set the clock.
Notes:
• If the EDS CH SET mode is set MANUAL mode in Step 3 and a channel that does not carry EDS signal is
selected in Step 4, the Auto Clock Setting function will not operate.
• In Step 4, the number of channels that can be selected depends on the mode setting on the CHANNEL PRESET
screen. See the table below.
• In Step 1, if you press the MENU button when operating the screen setting for the first time or after a power failure
AIR/CATV
CATV
AIR
01
02
03 …….124
125
01
02
03
04…….68
69
02
Channels to be selected
of more than 5 seconds, the LANGUAGE screen will appear.
• If you entered incorrect data during the setting procedure, re-enter the correct data in the following manner:
1. Use the cursor or button to select the data to be corrected.
2. Set the correct data with the cursor
or
button.
3. After correcting the data in Step 2, press the ENTER button to enter.
• If you press the MENU button in Step 5, the data will not be stored.
• If a button is not pressed within 3 minutes during the setting procedure, the screen will return to the normal screen.
Clock
Auto Clock Setting (If you DO know a channel that carries EDS signals)
Preparation
• Make sure that the antenna cable is connected and connect the power cord.
• Turn on your TV and select the video channel. (See Setting the 3
4 Output Channel.)
• Press the VCR ON/OFF button (VCR ON indicator will light up) and then press the TV/VCR button to select “VCR’.
(TAPE IN indicator will light up.)
Importants:
When using a cable box:
• See Cable TV connections.
• Leave POWER on the cable box turned on and select a channel that carries EDS signals.
1. Press the MEUN button.
Select “CLOCK” with the cursor
or
button and then press the ENTER button.
2. Select “AUTO” with the cursor
or
button and then press the ENTER button.
3. Set EDS CH SET mode to “ MANUAL” with the cursor or button and then press the cursor
button.
EDS CH SET AUTO
MANUAL
EDS CH 07
Normal
Screen
POWER
ENTER