Dolby Laboratories DVD/VCR Combo - Manual (Page 41)

- 41 -
Setting the 3 4 Output Channel
The 3 4 Output Channel lets your change the VCR OUTPUT to standard TV broadcasting signals. Both your
TV and VCR must be set to the same channel (i.e TV on channel 3 and VCR OUTPUT channel on 3 too).
1. Press the MAIN POWER button to turn the power off.
2. Press the TV/VCR button and if
VCR POWER, TIMER and VCR indicators light up flashing.
The VCR Output Channel is 3.
VCR Setup
(continue on next page) (continue on next page) (continue on next page) (continue on next page) (continue on next page)
3. To change Output Channel from 3 to 4 (or 4 to 3). Press the TV/VCR button for 2 seconds until VCR POWER,
TIMER, VCR and REC indicators (or VCR POWER, TIMER and VCR indicators) light up flashing. (As above)
4. Release the TV/VCR button, the Output Channel is set.
Notes:
• VCR Output Channel is automatically set during Set Up.
1. If Channel 3 (or 4) is an active broadcast channel in your area, the Channel 4 (or 3) will be set.
2. If both channel are the active channel or none active channel, the VCR Output Channel will be set to Channel
3.
• Cancelled the Set Up by pressing the VCR ON/OFF button during Set Up before setting the Output Channel.
VCR POWER, TIMER, VCR and REC indicators light up
flashing. The VCR Output Channel is 4.