OpenEye Gen6 N-Series - Manual (Page 26)

32521AD 27
The N4 is shipped with handles attached to the front of the unit. If you choose to mount the front bezel
to your recorder, you will need to remove the handles and attach the bezel before attaching the
rackmount rails.
1. Remove the two screws from each handle.
2. Install the include bezel clips and fasten with screws.
3. Align and slide the right side of the bezel into the right
clip.
4. Slide the left side of the bezel into the left clip.
5. Lock the bezel by turning the key counterclockwise.
1. Turn on the monitor and any external peripherals (ex. Printers, External Storage Devices, etc.)
connected to the recorder.
2. Turn on the Secondary Power Switch located in the rear of the recorder.
3. Press the Power Switch located on the front of the recorder.
4. The recorder will run a series of self-tests. If asked to respond to any messages, follow the
instructions carefully.
5. Startup is complete when the OpenEye recorder software is finished loading and displays the main
menu screen.
1. On the Live screen of the Server Software, click Exit .
2. Select Power Off from the list and click OK.
3. The recorder may take several minutes to shut down completely.
Always be sure to follow the proper procedures when turning off the power. NEVER
disconnect the power to the recorder while it is still running or in the process of shutting
down. Doing so can cause data loss, file corruption, system instability and hardware failure.