OpenEye Gen6 N-Series - Manual (Page 52)

32521AD 53
Use this function to activate a PTZ camera to move to a preset position when a sensor event is
detected.
1. Click Sensor / Preset .
2. Select the camera Channel you want to configure.
Note The camera channel must be a PTZ camera.
3. Select the appropriate Sensor .
4. Select the appropriate Preset position for the camera to move to when the selected Sensor is
activated..
Note The preset positions must be configured on your camera. Refer to the camera manual for
instructions.
5. Click Set .
6. Select a different Sensor and Preset combination, and then click Set .
7. Repeat for all of your desired sensors.
8. To delete a Sensor-Preset combination, select the combination in the list, and then click Delete .
9. Click OK .