OWON SDS Series - Manual (Page 102)

9.Technical Specifications
9. Technical Specifications
Unless otherwise specified, the technical specifications applied are for SDS series
only, and Probes attenuation set as 10X. Only if the oscilloscope fulfills the following
two conditions at first, these specification standards can be reached.
 This instrument should run for at least 30 minutes continuously under the
specified operating temperature.
 If change of the operating temperature is up to or exceeds 5℃, do a
"Self-calibration" procedure (see "How to Implement Self-calibration" on P15).
All specification standards can be fulfilled, except one(s) marked with the word
"Typical".
Performance Characteristics Instruction
Bandwidth
SDS6062(V) 60MHz
SDS7072(V) 70MHz
SDS7102(V) 100MHz
SDS8102(V) 100MHz
SDS8202(V) 200MHz
SDS8302 300MHz
SDS9302 300MHz
Channel 2 + 1 (External)
Acquisition
Mode Normal, Peak detect, Averaging
Sample rate
(real time)
SDS6062(V)
Dual CH 250MS/s
Single CH 500MS/s
SDS7072(V)
Dual CH 500MS/s
Single CH 1GS/s
SDS7102(V)
Dual CH 500MS/s
Single CH 1GS/s
SDS8102(V)
Dual CH 1GS/s
Single CH 2GS/s
SDS8202(V)
Dual CH 1GS/s
Single CH 2GS/s
SDS8302
Dual CH 1.25GS/s
Single CH 2.5GS/s
SDS9302
Dual CH 1.6GS/s
Single CH 3.2GS/s
Input
Input coupling DC, AC , Ground
Input impedance
1MΩ±2%, in parallel with 10pF±5pF
Probe attenuation
factor
1X, 10X, 100X, 1000X
Max. input voltage 400V (PK-PK) (DC + AC PK-PK)
97