OWON SDS Series - Manual (Page 89)

6.Communication with PC
Using LAN Port
Connect directly
(1) Connection. Plug in the LAN line to the LAN port in the right side panel of the
oscilloscope; plug the other end into the LAN interface of the computer.
(2) Set the network parameters of the computer. Since the oscilloscope can not
support obtaining an IP address automatically, you should assign a static IP address.
Here we set the IP address to 192.168.1.71.
Figure 6-2 Set the network parameters of the computer
(3) Set the network parameters of the OWON Oscilloscope Software. Run the
software on the computer; choose the "Ports-settings" of the "Communications" menu
item. Set "Connect using" to LAN. About the IP, the first three bytes is same as the IP
in the step (2), the last byte should be different. Here, we set it to 192.168.1.72. The
range of the port value is 0～4000, but the port which under 2000 is always be used,
so it is suggested to set it to the value above 2000. Here, we set it to 3000.
84