Progressive Turf Equipment TDR-30 - Manual (Page 19)

18
6. Lower the wing until the deck swivel mounting points align with the bushings
on the wing deck. Re-install the painted 1-1/4” pins through the bushings and
deck swivel. Secure the pins in place using the 3/8” bolts previously removed.
7. Install deck stop chains on wing decks
8. When it is safe to do so, fully raise the decks and secure each deck in the
transport position with the corresponding deck locks. Ensure the deck locks
function properly without binding and engage the matching lug on the wing
arm properly.
9. Inspect the front and rear stand-off arms and ensure that they engage the deck
lock mounts properly. If required, lower deck to ground, loosen (3) mounting
bolts on frame, adjust location of stand-off pin accordingly and re-tighten bolts.
Raise deck and re-check stand-off engagement.
10. Remove the TDR Spreader Fixture (526498).
11. When safe to do so, release the transport locks and carefully lower the decks to
the ground.
OUTER WING DECK INSTALLATION
1. Remove all banding from each deck pallet.
2. Using a lifting device with a minimum 700 lb. capacity, lift each outer wing
deck off of their shipping pallet and place beside each corresponding wing
deck.
Wood Block
Lift Pivot
Bar
LH Outer
Wing Frame
RH Outer
Wing
Deck