Progressive Turf Equipment TDR-30 - Manual (Page 34)

33
PRO LIFT-N-TURN ™ OPERATION
The industry exclusive Pro Lift-N-Turn™ system found on the TDR-30 mower offers
a real productivity advantage and is a feature not offered on competitive mowers.
With the Pro Lift-N-Turn™ system, Operators have the ability to raise the decks
slightly off the ground with the PTO still engaged. This makes turns at the end of the
pass easier and less stressful on both the turf and the equipment. With the TDR-30,
the Pro Lift-N-Turn must be activated in sequence.
1. Take the outside wing deck hydraulic circuit out of float position.
2. Lift the main decks until the wings stop at the lift and turn position.
3. Complete your turn.
4. Lower the main decks by putting the hydraulic lever for the main decks in float.
5. Lower the wing extension decks by putting the lever in float.
6. Continue mowing.
If you turn at high speed in the Lift-N-Turn position and there are
irregularities in the field, the wing decks can sway causing the
decks to come close to the ground, and possibly hit and catch. Use caution when
performing the Lift-N-Turn maneuver.
If the Pro Lift-N-Turn™ system is actuated with the PTO
running, and any of the latch plates are not in the correct position, the Pro Lift-
N-Turn™ system cannot prevent that deck from rising too far. Damage to the
PTO drive will result. It is the responsibility of the Operator to ensure the Pro
Lift-N-Turn™ system is functioning properly before use.
Pro Lift-N-Turn™ system in use.