Remotec ZXT-120 V1.6E - Manual (Page 11)

2 Look up below mapping table (value 0-22) for
learning, and decide the IR setting you intent
to learn next.
o For example "22 C, cool" which matches
value "5" (IR code to be learnt will locate at
"5" in ZXT-120). Set your original air
o conditioner remote at "22 C, cool" and turn it
off. (Besides temperature and mode, you
may set other desired settings, such as Fan,
Swing etc.)
Step Setup Key LED Indication Status
on ZXT-120
3 Go to configuration setting page on the
gateway or ZRC-100 and input parameter
number "25" and parameter value "5" (in this
case).
4 Press the PROG button on the ZXT-120. (this
step apply when using ZRC-100 or other
portable controller for set up, if using gateway,
user can skip this step) - LED flashes once when
Z X T - 1 2 0 r e c e i v e s t h e
configuration setting.
- LED flashes once again to
start learning.
5 Aim the original air conditioner remote at ZXT-
120 according to below position within 1-3 cm
Press "power on" button on the original air
conditioner remote.
If the learning is failed, repeat step 3 to step 5.
To learn next IR code, repeat step 2 to step 5.
- L E D f l a s h e s t w i c e i f
learning is successful.
- LED flashes 6 times if it's
failed.
1-3 cm
original remote
10