Remotec ZXT-120 V1.6E - Manual (Page 23)

All Z-Wave products also come with the Z-Wave
logo.
Frequently asked questions
Q Why won't my ZXT-120 work with the Z-Wave devices I purchased from another
country?
A Due to different countries regulations Z-Wave products from different regions are set
to different frequencies. Before purchasing new devices make sure you have checked
that the device is compatible in your region.
Q How do I know which product is compatible with my ZXT-120?
A ZXT-120 should work with any Z-Wave controller or gateway that has control
capability for "Thermostat" devices.
Q Can I use the USB port to configure ZXT-120?
A No, the mini USB port only provides an alternative option for user to power the ZXT-
120.
Q Do I need an electrician to install Z-Wave products in my house?
A Installation can be simple. In some cases all you need to do is mount the ZXT-120 to
a wall or wooden racks. You also can place the ZXT-120 on the desk and power it
with dry cell batteries.
Q How to select my air-conditioner IR code from ZXT-120?
A You should refer to the code list and look into the brand and try the code no.
sequentially until you find the right code. You can record down your device code
under the table for future reference after setting up the ZXT-120 correctly.
Q ZXT-120 is working on top and 4-directions IR output, but there is no response
on the IR emitter socket, why?
A ZXT-120 supports two IR power levels for the external IR emitter to avoid saturation of
the IR receiver. You can set the IR output power level by the Parameter Table value
(normal or high power mode) or adjust the position of your external IR emitter.
22