General programming tips – Skutt GlassMaster Kiln User Manual
Page 16
16
16
General Programming Tips
There are now 4 Menu Headings under the “MENU” key. They are:
• “SET”
Settings
• “dIAG”
Diagnostics
• “CNFG” Configurations
• “- - - -”
Other
For an overall look of all the available options consult the menu tree on page 23.
You can toggle through the Menu Headings by continuing to press the “MENU” key. When you reach the one you
wish to access, press “ENTER”. This will take you to the first Option in that submenu. If you want to toggle through
the various Options under the selected Menu Heading, press “MENU”. When you reach the Option you wish to
access, press “ENTER”.
When you select an Option you are asked to either:
• Toggle the Option ON/OFF
• Enter a Value
• Choose a Value
To toggle Options On/Off press the “1” key. When you get to the desired setting press “ENTER”. To enter a value
such as a Delay time or an Alarm temperature, input the value and press “ENTER”. To select a value press the
“MENU” key until your selection is displayed and then press “ENTER”.
“SET”
“SET”, or Set-Up, is where all of the commonly used Options are located. The following Options are available
under the “SET” Heading menu:
dELA (Delay)
Delay start allows the operator to program the kiln to automatically start at a later time. The option provides for a
delay programmed in hours and minutes up to 99 hours and 99 minutes.
To program a DELAY:
While the kiln is in IDLE mode access and select “dELAY” under the “SET” Menu Heading. Input the HOURS AND
MINUTES desired and press ENTER. When the program is started, the display will begin counting down from the
programmed delay time. The delay time is held in memory from one firing to another. To clear the option without
clearing the entire program, enter 00.00 for delay time.
ALRM (Alarm)
The Alarm sounds when the kiln has reached the alarm temperature programmed. The alarm sounds until it is turned
off by pressing ENTER. The alarm does not interrupt the firing nor does pressing Enter to stop the alarm. The alarm
temperature can be reset during a firing without disturbing the firing program. Do not press Stop during the firing to
reprogram the alarm.
To program an ALARM:
Access and select “ALRM” under the “SET” Menu Heading. Input the temperature desired and press ENTER. The
alarm temperature is held in memory from one firing to another. To clear the option without clearing the entire
program, enter 9999 for the temperature.
M
enu
f
eaTures