Smithco Envizio Pro Quick Reference Guide - Manual (Page 15)

1 4
AutoBoom
The following sections offer an overview of setting up and using an optional Glide
Series AutoBoom system with the Envizio Pro or Envizio Pro II. Refer to the
AutoBoom Calibration and Operation manual for detailed setup and calibration
information regarding the AutoBoom system.
To view the Glide Series AutoBoom settings and to enable automatic boom height
control, touch
, then and to access the Glide Series AutoBoom
setup screens.
Enabling AutoBoom While Staring a Job
1. Touch the icon on the Home screen and configure any necessary options
on the Start Job - Verify Settings screen.
2. Complete the procedure in the Start a Job section earlier in this guide and
select the to accept the displayed settings.
3. Before guidance will begin, the operator will be prompted to review the Glide
Series AutoBoom system settings.
The AutoBoom Setup screen will display similar to the following:
4. If is displayed in the upper right corner, touch the icon to toggle the
AutoBoom system on.
5. Touch the Left or Right Boom Disabled button to toggle automated boom
height control for each boom.
Warning: Booms may raise and lower unexpectedly. Make sure the area
around the booms is clear of obstructions and people before touching these
buttons.
6. Touch if system adjustments are necessary, or to fine tune the AutoBoom
system.
7. Touch the icon to open the job and begin guidance.