SP Controls PixiePlus - Manual (Page 21)

VII. Cloning cont’d
When the units are correctly lined up, the donor PixiePlus will automatically enter
cloning mode. Its Status LED will turn solid red and both units will chirp rapidly.
3. Hold the recipient steadily in front of the donor. If the connection is broken (the
recipient ceases to chirp), reposition the recipient unit to re-establish communica-
tion and the units will continue where they left off. If communication is broken for
more than 15 seconds, the recipient will time out of cloning mode and you will need
to begin again.
4. When the recipient has completed copying codes from the donor, it will beep 3
times and reset. After the PixiePlus has reset it will be fully operational with the
same codes and configuration settings programmed into the donor unit.
After cloning is complete, the donor unit will remain in cloning mode for 15 seconds
until it times out. It will then return to normal operation.
VIII. Complete Installation
To complete the installation, secure a Leviton Dec-
ora™ wall plate (not included) over the face of the
PixiePlus. The outer screw holes on the PixiePlus
should be used to secure the wall plate.
19