SP Controls SP3-AFVP+ - Manual (Page 11)

Aux Audio Cont’d
Aux Audio With the
Peripheral Switch
Aux Audio mode is best
implemented with the Aux
Audio peripheral switch
(part no. SLB-MINI-AUX-
AUDIO). This modular
switch is designed to
mount into the frame of
the Large Chassis
SmartPanel (SP2-CHAS),
or in the mini-module
cutouts of the SmartBox+
(SLB-SBOX+),
SmartDrawer (SLB-
1050B), or Rack Mount
kit with Mini-Mod Cut-
Outs (SP2-RACKSM-
MOD). The Aux Audio
peripheral switch should
be wired to the
SmartPanel as illustrated below.
The SmartPanel must be configured to use Aux Audio mode with the SP
Controls Product Configuration Utility (see SmartPanel Configuration
above).
Once the Aux Audio peripheral switch has been installed and the SmartPanel has been configured
for its use, press the switch to activate Aux Audio mode. The button on the Aux Audio switch will illu-
minate and the AFVP preamp will switch to the 5th stereo input. If the SmartPanel and projector are
off when the Aux Audio switch is pressed, the SmartPanel volume display will activate and you will
be able to control volume on the audio-only device normally without powering on the projector. If the
SmartPanel is on, the projector input will remain as selected, but audio will switch to the 5th audio
input.
Press the Aux Audio button again to return the SmartPanel to its normal state. If the projector is off,
the volume control will become inactive and the AFVP preamp output will mute. If the projector is
on, the SP3-AFVP+ preamp will return to the audio output corresponding to the selected input on
the SmartPanel.
SmartPanel Configuration
(Aux Audio with Peripheral
Switch)
Wiring Aux Audio
Peripheral Switch to
SmartPanel
Red
White
Black
email : [email protected]
web: spcontrols.com
phone: (877) 367-8444
SP Controls Inc.
930 Linden Ave.
S. San Francisco, CA 94080
Page 11