SP Controls SP3-AFVP+ - Manual (Page 8)

Mounting the AFVP
The AFVP was designed to mount to the back of the SP2-CHAS with the three screws provided. There
is no way to mount the AFVP to the SP2-SMCHAS due to its size limitations. If the AFVP is not mount-
ed directly to the SmartPanel, use the mounting wings provided on the bottom of the device to mount
the AFVP.
To the SP2-CHAS
1. Place the Preamp above the metal lip on the bottom rear side of the chassis.
2. Use the three screws provided to secure the Preamp in place.
3. Attach the 8-pin control cable to the chassis and then to the Preamp.
email : [email protected]
web: spcontrols.com
phone: (877) 367-8444
SP Controls Inc.
930 Linden Ave.
S. San Francisco, CA 94080
Page 8