Tech Source Raptor OpenWindows for Solaris - Manual (Page 17)

3-1
Chapter 3
SOFTWARE INSTALLATION FOR
I-CLASS CARDS
3.1 Overview
This chapter describes how to install and configure I-Class
Raptor cards. Installation of T-Class Raptor cards is covered in
Chapter 4. The following is a list of I-Class cards:
•
Raptor 1000
•
Raptor 2000
•
Raptor 2500
NOTE: This software must be installed on your system prior to
running OpenWindows on these cards.
The software for the I-Class cards is provided on CD-ROM or by
FTP and is composed of the following packages:
•
TSIrapw OpenWindows software
•
TSIrcfg Raptor configuration program
•
TSIrap 32-bit device driver for Raptor 1000 & 2000
cards
•
TSIrapx 64-bit device driver for Raptor 1000 & 2000
cards
•
TSIrapqfpx 64-bit device driver for Raptor 2500
•
TSIrapqfp 32-bit device driver for Raptor 2500
3.2 Requirements
The following are prerequisites for installing the Raptor
OpenWindows for Solaris Software:
•
The system is running Solaris 2.5.1 or higher.