Venstar T1900 - Manual (Page 55)

Page 11.5
Viewing the UV Light Run-Time
Press the PROGRAM button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
PROGRAM
Press
Counts the number of days
since the UV Light was last
reset. Press FAN to reset
the Service UV Light counter
and remove the icon from the
display.
Press
FAN
After the UV light has been operating for the number of days set in
step #17 below, the Service UV Light icon will appear. This counter
keeps track of the number of days since the UV light icon was last
reset.
0
UV Light
Setup
I7
PROGRAM
MODE
MODE
Press the MODE button. While holding
the MODE, press the PROGRAM
button to enter Setup screens.
Press the MODE button repeatedly
until this setup screen appears.
Service
Note: Press the MODE
button momentarily
to move through the
setup screens. Press
and hold the
MODE
button to move back-
wards through the
setup screens.
11