Venstar T1900 - Manual (Page 79)

Page 16.3
Controlling or Reading the
Remote Temperature (RS
1
)
The thermostat may be programmed to only READ the remote sensor,
or to CONTROL to the remote sensor. Refer to advanced setup step
#38, below.
Read Only Sensor (RS1): If step #38 is set to only READ to the
remote sensor, the thermostat will not use this sensor for
temperature control. This sensor may be viewed by pressing the
OUTDOOR button on the thermostat and then pressing the MODE
button.
Press the PROGRAM button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
PROGRAM
Press
Optional Remote Sensor:
YES = Read Only Remote
Sensor RS1.
NO = Control to Remote
Sensor RS1.
YES
NO
PROGRAM
MODE
MODE
Setup
38
Outside
Press the MODE button. While holding
the MODE, press the PROGRAM
button to enter Setup screens.
Press the MODE button repeatedly
until this setup screen appears.
Note: Press the MODE
button momentarily
to move through the
setup screens. Press
and hold the
MODE
button to move back-
wards through the
setup screens. 16
Control Sensor (RS1): If step #38 is set to CONTROL to the remote
sensor, the thermostat will ignore the reading of its internal
temperature sensor and only display the temperature reading from
the remote sensor. The degree icon on the thermostat will blink
once per second to indicate that a remote sensor reading is being
displayed.