Venstar T1900 - Manual (Page 89)

Page 20.1
When the thermostat is programmed for Vacation mode, it will take
effect at 12:00 am of the next day.
The thermostat will control to the cooling and heating setpoints set in
Vacation programming steps 2 and 3.
Vacation setpoints will be enforced for the number of days specified in
step #1 (0 - 99 days).
Press the PROGRAM and SET CLOCK buttons to
exit the setup screens. If no buttons are pressed, the
display will leave the setup screens after 30 seconds.
Adjust the heating
setpoint for Vacation
mode.
(35 - 99 )
Select the number of days
that the Vacation schedule
will be in effect. A value
of 0 disables Vacation
mode.
Adjust the cooling setpoint
for Vacation mode.
(35 - 99 )
2
C OOL
Setup 80
y
I
Setup 0
Vacation
Vacation
3
H EAT
Setup 65
Vacation
Press
MODE
Press
MODE
Press the SET CLOCK button. While
holding the SET CLOCK button, press
the PROGRAM button to enter the
Vacation programming setup steps.
You cannot set the Heat setpoint any higher than the Cool setpoint minus
the deadband setting in Advanced Setup step #23 on page 14.2.
SECTION 20
Programming Vacation Mode
20
(0 - 99 days)
PROGRAM SET CLOCK
VACATION
PROGRAM SET CLOCK
VACATION