Verilink PRISM 3111 (34-00242) Product Manual - Manual (Page 51)

Utilities 43
Date The current date is set by entering each digit in the standard MM/DD/YY date
format. Each field is range checked and automatically limited to the appropriate
range of values. For example, July 4, 1993 is entered as 070493.
Time The current time is set by entering each digit in the standard 24-hour HH:MM:SS
format. Each field is range checked and automatically limited to the appropriate
range of values. For example, 3:45 AM is entered as 0345 and 3:45 PM is entered
as 1545.
Set Password This field establishes the unit password used for entering the front panel interface
or the terminal interface. See page 75 for more information on establishing a
password.
Maint Rst This field will clear all user selectable parameters, performance registers,
passwords, and alarms but saves the IP Address supervisory port and SLIP port
rates. All alarm threshold parameters will be reset to default values. The unit
reloads start-up configuration settings from the default parameters stored in ROM.
Fact Rst This field clears all memory, including the IP Address, and uses the defaults from
the ROM.
Contrast Sets the LCD display contrast to a value between zero and 15. When scrolling
through the values, at some point the screen may appear blank. If this occurs,
continue scrolling until the contrast is best for viewing.
Download This field allows you to select the baud rate for downloading data to the unit.
Selections are No, 19.2, 38.4, and 57.6 kbps. The unit displays a verification
screen. A Yes reply allows you to put the unit into download mode. Refer to the
Flash PROM Download Procedures (TXPORT part number 45-00089) for specific
information concerning how to download the software to the unit.