Verilink WANsuite 6450 (34-00326) Product Manual - Manual (Page 148)

4-40 W A N s u i t e 6 4 5 0
Configuring the WANsuite 6450 for CES involves setting parameters not only
on the CES Service Details screen (Figure 4.34 on page 4-37), but also on the
CBR screen (Figure 4.16 on page 4-17); in some cases, the Serial screen
(Figure 4.21 on page 4-23); and the Channel Table Details screen (Figure 4.35
on page 4-40). The table below shows the settings required to maintain the
proper relationships among CBR framing, the CES Service Type, the CES
AAL1 format, and the Channel Rate.
*Only channels allocated to the CBR interface should be set to 56 k/Signaling. When configuring the Serial
interface for CES service (see "Serial CES Configuration" on page 4-42), you must set the Channel Rate
for allocated channels to 64 k.
Channels Table Details Screen
To allocate Channels, or time slots, for CES services, select the “Channels”
prompt at the bottom of the CES Service Details screen to bring up the Channel
Table Details screen shown in Figure 4.35.
Figure 4.35 Channel Table Details Screen
CES Service
Description
CBR
Framing
CES Service
Type
CES
AAL1
Format
Channel
Rate
Basic E1 E1 CCS Structured Basic 64 k
Basic T1 (ESF) T1 ESF Structured Basic 64 k
Basic T1 (D4) T1 D4 Structured Basic 64 k
E1 w/Signaling (ESF) E1 CAS Structured E1Cas 56 k/
Signaling*
T1 w/Signaling (ESF) T1 ESF Structured Ds1EsfCas 56 k/
Signaling*
T1 w/Signaling (D4) T1 D4 Structured Ds1SfCas 56 k/
Signaling*
Unstructured E1 E1 Unframed Unstructured Basic 64 k
Unstructured T1 T1 Unframed Basic 64 k