Verilink WANsuite 6450 (34-00326) Product Manual - Manual (Page 50)

3-22 W A N s u i t e 6 4 5 0
To make changes to a Serial port parameter, simply set the parameter to the
desired selection and press the “Submit” button.
10/100 Ethernet (IP Service Details)
The 10/100 Ethernet (IP Service Details) screen (Figure 3.18) lets you
configure the IP parameters described below.
Figure 3.18 10/100 Ethernet (IP Service Details) Screen
Unit IP Address A unique Network address assigned to this unit.
Subnet Mask Defines the Network portion of the unit’s IP Address.
Gateway IP Address IP Address of the default gateway (router) on the LAN side of the unit.
DHCP Client If DHCP Client is enabled at power-up, the unit will request its IP, Mask, and
Gateway addresses from a DHCP server located on the LAN side of the unit,
and the unit will use these addresses. If the DHCP request is unsuccessful, the
unit will use the configured addresses shown on this screen.
Client Identifier Displays a unique identifier for a specific IP address.
Ethernet Enables or disables a remote unit’s Ethernet port.
Physical Address Displays unique MAC address.
NOTICE: To use newly established IP parameters, you must “Submit” and “Save
and Restart.” (See Save and Restart as described on page 3-5.) The
parameters above can also be configured using the Installation Wizard
as described on page 2-2.
To view details about the current condition of IP, ICMP (In and Out), TCP,
and UDP parameters, click on the “Ethernet Stats” button at the bottom of the