Wavetronix SmartSensor 105 (SS-105) - User Guide - Manual (Page 15)

14 CHAPTER 1 • INSTALLING THE SMARTSENSOR 105
Figure 1.2 – Attaching the Mount Bracket to the Pole
Caution
Depending on the site and type of traffic, the sensor may tend to over or undercount.
If the sensor is overcounting, reduce the height of the sensor by three ft. (0.9 m) and
reconfigure the sensor. If the sensor is undercounting, increase the height of the sen-
sor by three ft. (0.9 m) and reconfigure. Normally, reducing the height of the sensor
improves performance.
Attaching the Sensor to the Mount Bracket
Use the following steps to securely fasten the sensor to the mount bracket (see Figure 1.3).
1 Align the bolts on the back of the SmartSensor with the holes in the mounting brack-
et. The large 25-pin connector on the SmartSensor should be pointing towards the
ground.
2 Place the lock washers onto the bolts after the bolts are in the mounting bracket holes.
3 Thread on the nuts and tighten.