Westermo EDW-100 - Manual (Page 15)

15 6616-2203
Getting started
IP Address
The default IP address of the EDW-100 when delivered is 169.254.100.100.
Default port 9000
Default gateway 169.254.100.1
IP address configuration
The IP address is configurable by the Web tool and/or by using a terminal program.
Below is an description of how to configure the IP address by using a terminal program.
1. If the address is known, connect the unit from a Web browser with the address to
EDW-100. If the address is unknown, connect the serial RS-232 interface to a terminal
program with settings:
Data rate: 9600 bit/s
Data bits: 8
Stop bits: 1
Parity: None
Flow control: None
EDW-100
DTE
3
2
7
8
6
5
1
4
9 3
2
7
8
6
5
1
4
9
Computer
DTE
Note! When connecting EDW-100 to a Comport in a
computer you have to use a “Cross-over” cable,
because both EDW-100 and the computer
interface is DTE. 1.8 m standard cable is supported by Westermo art.no.
1211-2172.
2. Setting DIP S1:1 to ‘On’ and power-up the EDW-100 will enable the local IP address
to be configured via serial interface.
Once connected with the terminal program you can change the IP address, Gateway
address and Subnet Mask according to the picture below:
3. Set DIP S1:1 to ‘Off’ and power cycle the EDW-100.
4. The unit is now ready for a complete configuration by the Web tool.
Address EDW-100 in a browser with the configured IP address.
Note that the used computer have to be on the same
New Connection - Hyper Terminal
File
'EDW-100 IP CONFIGURATION'
Firmware : 4100-9002
-- Current IP configuration --
Local IP address : 169.254.100.100
Gateway address : 169.254.100.1
Subnet Mask address : 255.255.255.0
Press <Return> to select the value shown in braces,
or enter a new value.
Local IP address [169.254.100.100]?
Edit View Call Transfer
Connected 0:01:33 VT100 9600 8-N-1 NUM SCROLL CAPS Capture Print echo
Help
See also configuration by
Web Tool on page 14