Westermo ID-90 - Manual (Page 67)

67 6607-2204
Remote access control
Using the following commands you can setup a table, to allow only dedicated callers to get
a connection to the remote management facilities inside the TA.
If this list is empty (default) or one entry with a star (*) is set, any incoming call is allowed.
Every incoming call that does not fit to one of the entries of acctab will be rejected with the
ISDN cause “call rejected”.
racctabx nn/ss set entry number x to ISDN number nn and subaddress ss
racctabx -
clear entry number x
racctabx * Allow all incoming calls to be accepted
racctabx Show entry number x
racctab Show all entries
Maximum number of entries = 3
Maximum length of ISDN number = 20 digits
Maximum length of subaddress = 20 digits
The ISDN number can contain wildcards:
*: represents one or more digits
?: represents exactly one digits
Example: racctab1 1234567890; accept the only specified number
racctab2 *456* ; accept all number with 456 somewhere in the
middle
racctab3 ?2345678?? ; accept all number with 2345678 in the middle
peceeded by one digit and followed by two digits.
racctab3 * ; accept all incoming calls
racctab3 - ; clear entry no. 3
List of TA+Configurator commands
The TA+Configuration commands typed in must have the correct syntax and be complete,
including all blanks. Capital/small letter use is not important. The entry is not case sensitive.
The bolded values are factory defaults. The usage is:
[?]<command>[=parameter]
Example to set the ISDN B channel protocol to X.75:
prot=10
Example to show the selected ISDN protocol:
prot
Example to show all selectable ISDN protocols:
?prot