AIRLESSCO TS1500 - Manual (Page 16)

Maintenance
16 3A1183D
4. Soak all leather packings in SAE 30W oil for 1 hour
minimum prior to assembly. Place male gland (204)
in cylinder. Alternately stack (UHMWPE (203) and
leather packings (223) (note orientation). Place
female gland (224) in top of cylinder. Seat packings.
5. Install seal (201) into packing nut (202), Install
throat adjustment spacer (228) onto packing nut.
Loosely install packing nut into cylinder.
6. Grease piston packings.
7. Slide piston assembly into bottom of sleeve.
8. Grease top inch or two of piston rod that will go
through the cylinder throat packings.
9. Grease O-rings (221) and place on sleeve. Slide
sleeve/piston rod assembly into bottom of cylinder.
Replace O-ring (207) if desired.
203
224
223
204
7573f
7581a
201
202
228
NOTICE
Do not slide piston assembly into top of sleeve as
this may damage piston packing.
7578c
7577a
7579a