Airlink RT210W - Manual (Page 43)

Wireless Broadband Router User Manual
33
•
Wireless Bridge. Provides wireless connectivity between
two or more wired segment. When operating as Wireless
Bridge, the device does not accept association request
from wireless stations. All bridging devices must use the
same channel in order to communicate with each other.
Figure 4-13 Wireless Bridge Mode
Bridge Restrict: Select whether to enable or disable this function.
When set to enabled, all devices operating in Wireless Bridge mode
must have others’ Wireless Interface MAC addresses in their
respective Remote Bridges table in order to establish the
connection with each other (more secure). When set to disabled,
only one device is required to have the Remote Bridges table filled
with the Wireless Interface MAC address of other Wireless
Broadband Router in order to establish the connection.
Remote Bridges: Enter the Wireless Interface’ s MAC address of
the remote Wireless Broadband Router in this field. The remote
device should also enter this Access Point’ s MAC address in its
Remote Bridges table if the Bridge Restrict is enabled. Enter up to
four MAC address of the remote bridge. To find the MAC address of
this device, see Wireless Interface, in the beginning of this section.