Amer Networks WLO220T CLI - Manual (Page 77)

C O M M A N D D E S C R I P T I O N S
service
2
74 CLI Reference Guide
protocol
- Defines the service by IP protocol.
- Defines a protocol for the specified service.
 tcp specifies a TCP-based service.
 udp specifies a UDP-based service.
Example
The following command sets a service named “ipsec” that uses protocol 50:
set service ipsec protocol 50
src-port | dst-port
set service svc_name protocol { ... }
[ src-port number - number ] [ dst-port number - number
]
src-port
Defines a range of source port numbers valid for the service and protocol.
dst-port
Defines a range of destination port numbers valid for the service and protocol.
Example
The following command sets a service named “test1” that uses destination tcp port 1001:
set service test1 protocol tcp src-port 0-65535 dst-port 1001-1001
timeout
get service timeout { other | tcp | udp } ]
set service svc_name timeout { number | never }
unset service svc_name timeout
timeout
Sets or displays the timeout value for session sessions created on a port for TCP, UDP, or other
protocols. You can specify session timeout value (<number>) in minutes, or as never.
user
get service user
user
Displays all user-defined services.
Defaults
The default timeout for TCP connections is 30 minutes.