Amer Networks WLO220T CLI - Manual (Page 87)

C O M M A N D D E S C R I P T I O N S
top-talkers
2
84 CLI Reference Guide
Example
The following command informs the software to ignore the flow if its received byte count is less
than 100 bytes.
set top-talkers match byte-range min 100
packet-range
set top-talkers match packet-range min min-packet
packet-range
The match criteria is based on the minimum packet count of the top-talkers. If the received
packet count of a flow is less than the minimum value, the software will not treat it as a top-
talkers candidate. This criterion is meaningful if the top-talkers are addressed-based.
The valid value range is from 1 to (2 ^ 31 -1). The default is to ignore the packet-range.
Example
The following command informs the software to ignore flow its received packet count if it is less
than 5.
Set top-talkers match packet-range min 5
incoming-interface
set top-talkers match incoming-interface interface-name
incoming-interface
The match criterion is based on the incoming interface. The default is to ignore the incoming-
interface.
Example
The following command informs the software to ignore a flow if its incoming interface is not eth0.
Set top-talkers match incoming-interface eth0
nexthop
set top-talkers match nexthop ip-address
nexthop
The match criteria is based on the next-hop IP address. The default is to ignore the nexthop.
Example
The following command informs the software to ignore a flow if its nexthop is not 10.1.1.255.
set top-talkers match nexthop 10.1.1.255