ARAG Bravo 300s series computers crop spraying - Direct connection - INSTALLATION - Manual (Page 13)

13
All ARAG sensors use the same type of connector. Connect the sensor connector to the relevant
harness; make sure it is correctly fitted and push it until locking it.
Fig. 11a Fig. 11b
8.4 SD memory card
The SD memory card is used to exchange data with the Bravo 300S computer.
Before using it, make sure the card is not protected (Fig. 12b).
ONLY use the SD card supplied with the package.
Fig. 12a Fig. 12b
Before inserting or removing the SD memory card ALWAYS switch off the computer.
• Insertion:
Insert the memory card making sure to orient it correctly:
the card cut edge
A must be face downward; push the card
until it engages into place and close the slot with the cover.
• Removal:
Press and immediately release the card into the slot and
slide it out.
The SD memory card shall be inserted with computer off and must be left there
during computer operation.
If the SD memory card is not inserted in the computer, or if it is inserted after compu-
ter switching on, this will cause an error.
Store the SD memory card into the suitable case (supplied) when not in use.
Fig. 13