ARM Electronics DVRHD - Manual (Page 34)

DVR User’s Manual
33
3.7.8.1 Channel Select
The item is used to select a desired channel for setting the parameters. Move
the cursor to <Channel Select> and press ENTER, then select a channel
using UP / DOWN keys. Press ENTER again to confirm the selection.
3.7.8.2 Video Loss Detect
This item allows users to enable or disable Video Loss as an alarm event.
Select <ON> to enable Video Loss alarm events, or <OFF> to disable.
3.7.8.3 Motion Detect
This item allows users to enable or disable motion detection function of the
DVR. Select <ON> to enable Motion Detect alarm events, or <OFF> to
disable. If motion detection function is enabled, it is required to define motion
detection parameters such as detection area and sensitivity settings in
<Detection Config>.
3.7.8.4 Motion Detect Indicator
This item allows users to display/ hide the motion detection indicators. Select
<ON> to display the indicators, or <OFF> to hide them.
3.7.8.5 Detection Configuration
If motion detection function is enabled, it is required to define the motion
detection parameters such as detection area and sensitivity settings. Select a
channel for setting the parameters, move the cursor to <Detection Config>
and press ENTER. The Detection Configuration menu displays as follows.
Detection Config
Detected Area Setup
Sensitivity
Block Threshold
88%
4
Detected Area Setup
After selected this item, the detected area is displayed as follows. The
detection area consists of 192 (16×12) detection grids.