ARM Electronics ENDVR9A - Manual (Page 16)

12
(MENU)
SEARCH
TIMER
► RECORD
CAMERA
SYSTEM
EVENT
NETWORK
(MENU)
SEARCH
TIMER
RECORD
► CAMERA
SYSTEM
EVENT
NETWORK
RECORD
1. HDD OVERWRITE
Select “YES” to overwrite previous recording video in HDD.
NOTE : When the HDD is full under O/W Recording mode, previous recorded files
may be overwritten without further warning notices.
2. RECORD IPS
Select the images per second of recording. The options are
as following :
NTSC－25A、15、8、4、2、1
PAL－18A、12、6、3、2、1
NOTE : “A” means “Record with Audio ”.
3. RECORD QUALITY
There are four quality settings : BEST, HIGH, NORMAL and BASIC.
NOTE : The relationship of Record time, IPS and record quality,
please refer to page.48 Recording Speed.
4. ALARM REC IPS
Select the images per second of recording during an Alarm. The options are as following :
NTSC－25A、15、8、4、2、1
PAL－18A、12、6、3、2、1
NOTE : “A” means “ Record with Audio”.
5. ALARM REC QUALITY
There are four quality settings during an Alarm : BEST, HIGH, NORMAL and BASIC.
NOTE : The relationship of Record time, IPS and record quality, please refer to page.48 Recording Speed.
6. MOTION TRIGGER RECORD
When you set up the MOTION DETECTION function (Please refer to Page.13 for MOTION DETECTION SETUP),
1. Select “ON” to set up the motion trigger record: It can automatically switch from stand-by mode to Record Mode. The
motion detection will change the scanning sequence and show and “D” on the monitor.
NOTE: The trigger recording time will depend on ALARM DURATION mode setting (Please refer to page.9 for ALARM DURATION)
and it will record from the last trigger time. For example, when the alarm duration setting is 1 min, the recording time is from 9:00:00
to 9:01:00. If the motion detection trigged again at 9:00:40, the trigged recording time will be from 9:00:00 to 9:00:40 and 9:00:40 to
9:01:40. The total recording time is 00:01:40.
2. Select ”OFF”: The screen shows , the motion detection will change the scanning sequence while in record mode and shows
“M”on the monitor.
3. (Brightness) / (Contrast) / (Color)
Have a video adjustment (Brightness / Contrast / Color) of each channel. The level is from 0 to 9.
4. ALARM
Select LOW / OFF / HIGH for alarm polarity. The default value is LOW.
5. RECORD
Set up which channel you want to record during alarm trigger. The DMR record methods are as below :
EVENT : when alarm input is triggered, DMR will record alarming channel more frequently.
For example : when CH01 is triggered, the record method will become 1-2-1-3-1-4….
NORMAL : when alarm input is triggered, DMR will record normally as set up.
OFF : when alarm input is triggered, DMR will not record.
(RECORD)
► HDD OVERWRITE: NO
RECORD IPS: 25A
RECORD QUALITY : NORMAL
ALARM REC IPS: 25A
ALARM REC QUALITY : HIGH
MOTION TRIGGER RECORD: ON
CAMERA
1. TITLE
Assign a title to each camera input. Initially each title is the camera’s number.
2. DWELL
Select “ON” to set up the channel auto switching on the call monitor.