Caution – MOCET IP3072 User Manual
Page 11
Page 11
Page 11
MOCET IP3072 Smart Office IP Desk Phone User Guide
Step 3: Then snap the “3rd” antler into the slot “C” hole (it may take a bit of pressure, but
when it locks in place, you will hear a click and the stand will not wiggle on the
phone.)
For other stand angle, such as 51° and 30°, please refer to the Installation Combination
Table below to find correct slots and correct antlers to use.
Snapping the slot “B” hole with the antler of stand first is the most
important step for a smooth installation. The product sticker on stand
should be facing inward towards the phone. When a stand is installed at 60° or 30°, you
can rotate the stand between 30° and 60° quickly without pulling the antler in the slot B out.
1.3.2 Detaching the Stand from the Phone:
To remove the stand from the IP3072 phone, follow the procedures below (we are using a
60° stand as an example):
Step
: Place the main body of the IP phone face down in your lap or a firm sofa;
Step
: Press with one hand on the back of the IP phone and firmly pull the “3rd” antler
straight out of the slot “C” hole;
Step
: Press with one hand on the back of the IP phone and firmly pull the “2nd” antler
straight out of the slot “B” hole.
CAUTION