8 pattern – Eneo EDC-3371 User Manual
Page 17
7
4.8 Pattern
(Shortcut:
PTRN)
The Pattern feature records user control of the selected dome camera. Up to four 8 patterns can be stored and played back by pressing No.+
PTRN keys
subsequently.
PATTERN SETUP
(CTRL KEY)
NO.
TITLE
SEC
PERCENT
0:
P0
000
00.0%
0:
P0
000
00.0%
03:
P03
000
00.0%
04:
P04
000
00.0%
05:
P05
000
00.0%
06:
P06
000
00.0%
07:
P07
000
00.0%
08:
P08
000
00.0%
TOTAL:
0000
00.0%
SAVE AND EXIT (ESC TO CANCEL)
Follow steps below to program the Pattern:
. Press
MENU to display the main menu on the monitor. Scroll to Pattern and push the Joystick to the right to enter the pattern menu. Or just press the
PTRN key on the keyboard.
. Select the desired pattern to be programmed by pushing the
Joystick Up or Down. If the pattern is not 000, a pattern has already been recorded.
Patterns can be overwritten.
3. Press and hold down the
CTRL key while controlling the camera direction and zoom with the Joystick. The dome will be automatically recorded until you
release the
CTRL key. Or Press IRIS OPEN then the „CTRL” displays. Move the position and the zoom position. Press IRIS CLOSE then the „CTRL”
disappears.
4. Select Save and Exit and push the
Joystick to the right. Press ESC to exit the program without saving.
5. To edit the title, follow the procedure of the auto scan above to edit titles.
NOTE: Press the HOME key at any programmed position to delete the pattern.
NOTE: If total recording time reaches 500 seconds, it will automatically stop for a moment.
Press
PTRN key on the title field to display with the small OSD. Then the screen will show as below.
The setting procedure is the same as above.
PATTERN AREA SETUP
(CTRL KEY)
NUMBER 0
000
00.0%
000
0.0%
EXIT(ESC TO EXIT)