Eneo EDC-3371 User Manual
Page 26
6
• INITIALIZE DATA
INITIALIZE DATA
FACTORY DEFAULT
ERASE PROGRAMMED DATA
PRESET FOCUS DEFAULT
EXIT (ESC TO CANCEL)
FACTORY DEFAULT
Select the Factory Default to initialize the Data.
FACTORY DEFAULT
ARE YOU SURE ?
CANCEL
OK
ERASE PROGRAMMED DATA
Erase all stored data from the Flash-ROM of the selected dome camera. You will be asked to enter ON or OFF. If you desire to erase all data then select
the Erase Run, otherwise press the
ESC key to exit without erasing. The erased data includes all stored data (auto scan, presets, and tours….) except
origin offset.
The offset value is still valid after all data is erased. The offset value can be zero with default set of Offset origin menu.
PRESET FOCUS DEFAULT
FOCUS:
AUTO
SAVE AND EXIT (ESC TO CANCEL)
ERASE PROGRAMMED DATA
AUTO SCAN:
ON
PRESET:
ON
TOUR:
ON
PATTERN:
ON
ALARM:
ON
AREA TITLE:
ON
PRIVACY ZONE:
ON
CAMERA:
ON
DOME SETUP:
ON
ERASE
SAVE AND EXIT (ESC TO CANCEL)
PRESET FOCUS DEFAULT
This menu set the default mode of the focus when you save the preset.
FOCUS
AUTO / MANUAL / ONE PUSH