Eneo EDC-3371 User Manual
Page 25
5
• VIEW ANGLE SETUP
VIEW ANGLE SETUP
PANNING RANGE
FLIP:
90°
TILT OVER ANGLE:
ON
SAVE AND EXIT (ESC TO CANCEL)
. Place the dome camera under 90 degree vertically.
. Set the right limit by pushing the
Joystick to the right.
3. Set the left limit by pushing the
Joystick to the left.
4. Set ENABLE to ON to use
To exchange the right and the left limit, set SWAP to ON.
To apply limits on the auto pan (endless panning), set AUTO PAN to ON.
NOTE: When you use the panning range, we recommend using the flip mode to AUTO. When the flip mode is 90°, 100°, 110° or 120° and you
moves over 90° vertically, the panning range operates in opposite side.
(AREA TITLE)
(AF AE)
(FUNC TITLE)
(CTRL KEY TO MOVE)
SAVE AND EXIT (ESC TO CANCEL)
(ALARM MESSAGE)
DOME ID...XXXX
XXX.X XXX.X
PANNING RANGE SETUP
(CTRL KEY)
RIGHT LIMIT:
000.0
LEFT LIMIT:
000.0
ENABLE:
OFF
SWAP:
OFF
AUTO PAN:
OFF
SAVE AND EXIT (ESC TO CANCEL)
PANNING RANGE
When the dome camera is installed near a wall, panning range can be limited by user.
FLIP
ON,OFF
OFF:
The dome camera moves until 90° vertically.
90°, 100°, 110°, 120°: Allows the image to flip digitally when the camera moves over the setting angle vertically.
AUTO:
When the camera reaches the floor directly above the moving object, it will stop. At that time, release the
Joystick handle instantly and pull it down again to run the auto-flip function. When you use the panning
range, we recommend using the flip mode to AUTO.
TILT OVER ANGLE This option is used to set the limit of the horizontal view angle so that the trim ring or ceiling does not obstruct the horizontal image
when zooming out (wide angle).
ON:
In some installations it is desirable for the dome camera to be able to see above the horizon. When this
option is chosen, the dome will tilt up over the horizon (About -0 degrees). When the lens is zoomed out,
you can see the ceiling line. But when the lens is zoomed in, the viewing angle is narrower, and the ceiling
line disappears.
Without Bubble:
The tilt range of the camera is limited to see the horizon so the picture shows part of the ceiling line.
With Bubble:
The tilt range of the camera is limited to see below the horizon (0 degrees).
Over Angle is not sufficient enough to avoid ceiling obstructions, please adjust Origin Offset of tilt angle as described below.