Ensemble Designs BrightEye 57 3G/HD/SD/Analog Test Signal and Sync Pulse Generator - Manual (Page 22)

www.ensembledesigns.com BrightEye 57
TM BrightEye 57 3G/HD/SD/Analog Test Signal and Sync Pulse Generator User Guide
Page 22
HD Format
The currently selected HD Format (1080i, 720p, 1080p, or 1080sF) is illuminated green. The Tri Level
Sync (TLS) frame rate is determined by the selections made in the Standard, Mode and HD Format
fields in the Format menu of the BrightEye Control application.
Ref (Reference)
The status indicator will be green when a valid reference is present and locked.
Std (Standard)
The currently selected output standard (NTSC or PAL) illuminates green.
Mode
The currently selected mode (SD, HD, 3G) Illuminates green.
Memory Card Status
Illuminates green when a Secure Digital (SD) flash memory card is correctly inserted into the SD card
slot.
Pwr (Power)
Illuminates green when the BrightEye unit has power and the internal voltage regulator is functioning
correctly.
Adjusting Parameters from the Front Panel
Use the Mode, Right Arrow, and Left Arrow buttons to select and adjust parameters from the front
panel.
Pressing the Mode button activates the front panel for editing and tabs between each section of
editable parameters.
Pressing the Right Arrow or Left Arrow advances the selection within a given section of parameters,
or increases (Right Arrow) or decreases (Left Arrow) the value of a selected parameter.
Note: The LED of an edited parameter will blink for 15 seconds, after which time its value is
stored in memory. If power is interrupted before this 15 second timeout period has
elapsed, the edited state will not be saved.